Message 3 of Message 4 of Message 7 of 9. Message 4 of Message 9 of 9. Can you attach that file directly to a post.

Uploader: Gardagami
Date Added: 28 December 2013
File Size: 25.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 3444
Price: Free* [*Free Regsitration Required]

There is the Instrument Driver Guidelines that has links to tools and documents that help a great deal.

Most Active Hardware Boards: You could use portmon to watch the data traffic. I’ve done a simple “loop-back” testto confirm my RS port is working, which it appears to be. Message 3 of 9.

MKS Instruments C Multi Gas Controller – Instrument Driver – National Instruments

Here, the flow rates of each channel are collected in an array and the whole array is the input for the graph. Message 10 of I am at a loss in regards to how to write this loop, and I am currently trying to figure out how LabVIEW goes about timing runs and labvirw to go about calling out the labvew that the user inputs. If you run into any problems with the drivers I did nothere is a link to the user manual: They are showing flow values, units etc.


I downloaded the zip file. But I am unable to. HyperTerminal was labviww go-to after neither the MAX or LabView worked out, but this too showed no effect on the instrument.

mks c control – Discussion Forums – National Instruments

I have not been able to communicate with the device at all, be it from Labview v. Message 3 of Message 7 of Also, what programming language are you hoping to control the instrument with? Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. I have copy pasted drivers? Especially for Channel 2 where the Gas Correction Factor is not equal to one?

MKS Instruments mks647c Controller

From the driver, I can read the data from instrument. I would get in touch with the manufacturer to see if you can establish communication between this instrument and any computer. Temporal, have you been able to develop drivers for the MKS flow controller?

Possibly through HyperTerminal or any software that the manufacturer provided you with just so that we can confirm that the setup between labvirw device and the computer is correct. Did you found a driver?


You’ve got several options if the vendor or someone who views this forum doesn’t labvoew a driver. Did you “tweak” those drivers at all in order to communicate? I have connected the cables from MF1s to C. Are the measured values in the example program the same as in the display of the actual device?

Instrument Control (GPIB, Serial, VISA, IVI)

Do any of those work? Message 1 of 9.

Have you been able to communicate with the device through any means at all from your computer? Message 2 of I have just basic idea of LabView.

Message 1 of